tOfficial Night Shift Thread v61 with less Gophers, Voles and Fake Birds

Status
Not open for further replies.
18 pages of crap?

Nah.

Just dropping by to tell you I'll be out next week and I have an interview coming up on Friday.
You're not taking Bosszilla's job?
 
Also @steelerssb Should I dump that AMC stock yet? It doesn't seem to be getting above $60. And did you see that thing about getting in on the pre-IPO stuff with robinhood? Is it a total lottery?
 
xIMG_1550-300x225.jpg


next time you need to predrill, put tape on the drill bit like this. Then you will know when it is deep enough.

Also, to choose the right bit to predrill, you should be able to hold the drill bit over the screw, length wise, and the shaft of the screw should be almost completely gone, but you can still see the threads of the screw.
what about those little fuckers (anchors) you hammer into wall so they expand to hold the nail.

i always and almost always smashed them when i try to hammer them in.
 
what about those little fuckers (anchors) you hammer into wall so they expand to hold the nail.

i always and almost always smashed them when i try to hammer them in.
Same. Should be just slightly smaller than th wall Molly. Usually drill the hole the same size as the screw, including the threads, then tap it in. Some times I will put the screw in the Molly, 1/4" or so, and then tap the Molly in with the screw. Depends on the type.
 
Anyone remember when this damn dog last had her period? Can't remember if it was March or April. Anywho... she's getting all super clingy again. I bet she's getting another one. Her stupid appointment to get fixed is next month and she's going to RUIN IT!!!!
 
Anyone remember when this damn dog last had her period? Can't remember if it was March or April. Anywho... she's getting all super clingy again. I bet she's getting another one. Her stupid appointment to get fixed is next month and she's going to RUIN IT!!!!
She’s probably already pregnant if anything like her owner
 
I thought his wife told him to retire and he wanted you to take over ?
He says that all the time but I stopped believing him. Dude would drop dead if he didn't have a job
 
Also @steelerssb Should I dump that AMC stock yet? It doesn't seem to be getting above $60. And did you see that thing about getting in on the pre-IPO stuff with robinhood? Is it a total lottery?
Goddamn that shit went up AGAIN? Ehh... might as well hold it unless it nose dives.
 
Status
Not open for further replies.
Back
Top